![]() ![]() But trying to access the device with my application will be aborted by error, it seems the system description still holds the error message. ![]() After the driver is detected, you see the STMicroelectronics STLink dongle under. In the Browse window, specify the path of the folder that you have unzipped, for example, C:en.stsw-link009. Select the option Browse my computer for driver software. If plugged in again it is possible to read the Windows Device Description by USBTreeView and the device is shown in the display without any error. Right-click Device Manager > Other Devices > ST-Link Debug and then click Update Driver Software. Updated 2023.03.01: Zadig 2.8 (5.0 MB) Other versions System Requirements: Windows 7 or later. This error disappears in case of unplug and replug of the device USB connection. you want to upgrade a generic USB driver you want to access a device using WinUSB Note: 'libusb-based' above means an application that uses either libusb, libusb-win32 or libusbK. With Windows-10, I am observing that if I log in as Admin, I am able to install Virtual Com Port Driver X64 (VCPV1.3.1Setup.exe) prerequisite as well as able to install software too but with other non-admin accounts where I am supposed to supply Admin Credentials, software install seems to be hung while installing Virtual Com Port Driver 圆4. The interface problem melts down to a corrupted USB Device Description for the STM-Driver with the windows error message ConfigDescriptor 1 Error : ERROR_CRC. I am the first to use the board in conjunction with an FTDI-Controller and this is where the problems became severe.īy protocoling on both USB-Interfaces with some USB-Sniffer I can say that there is no direct interference on both channels in communication. But for this, Windows users will require dedicated driver. SMT32 can work as USB device too after all. No more onboard USB-to-UART converters like CP2102. 64bit and windows 7, to make sure Version 1.5.0 is installed though this one comes with a 1.3.1 in the driver details.Ībout the SW on the controller board, I don't have any idea but it's used in the house with a lot of different set up's working. Virtual Com Port, VCP to method of choice for almost all recent flight controllers to connect to PCs. Yes, did follow the instructions well, I made a deinstall with driver-SW-erase of the previous driver before installing the new driver with adequate attributes, i.e. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |